Cryptoauth Xplained Configuration

Configuring a CRYPTOAUTH-XPRO or CRYPTOAUTH-XPRO-B

Included in the .\scripts folder is a utility to program blank evaluation devices. In order to program the device the WINC1500-XPRO can not be attached to the target.

1. Remove the ATWINC1500-XPRO board from the target
2. Attach the Target USB to the host PC
3. Run the following command

>scripts\at_config.py

The resulting output should be:

Getting the Kit Type
    AT88CK101STK Found

Getting the Device Info
    Device type is 608

Getting the I2C Address
    Current Address: B0
    New Address: B0

Reading the Lock Status
    Config Zone: Unlocked
    Data Zone: Unlocked

Program Configuration
    Programming ATECC608A Configuration
        Success
    Verifying Configuration
        Success
    Locking Configuration
        Locked

Activating Configuration
    Activated

Generating New Keys
    Key 0 Success
    Key 2 Success
    Key 3 Success
    Key 7 Success

Device Successfully Configured

4. Extract the public key from the device using the following command

>scripts\at_pubkey.py