Firmata implementation for the Pharo Programming Language.
To load latest version of Firmata you can evaluate the following expression in playground:
Metacello new
baseline: 'Firmata';
repository: 'github://pharo-iot/Firmata';
loadTo connect to your firmatata enable device, you need the following things:
- know the device's port name
- know its baud rate
- install firmata in it (you can do it using your arduino IDE)
We have tested this library so far with Arduino Uno and Funduino Uno. In our example, our Arduino boards use a baud rate of 57600, and were detected by our operating system in the /dev/ttyACM0 port. Connecting the Firmata client to arduino is as easy as follows:
firmata := Firmata onPort: '/dev/ttyACM0' baudRate: 57600.Connecting to an arduino will check that the port exists, and will verify that Arduino has installed a compatible version of Firmata. In case one of these conditions does not hold, an exception is thrown.
Once we are connected, we can ask the Firmata driver if it is connected or not.
firmata isConnected.
=> trueAnd finally, we can disconnect it by doing:
firmata disconnect.Digital pins are pins whose state is either on or off. These states are represented by the binary values 1 and 0.
Digital pins work either in read or write mode. In other words, we can use them to obtain a digital value (for example, if a button is pressed or not), or to set a value (set if a led is turned on or off) but not both at the same time.
To write to a digital pin, you should first set it to output mode using the #digitalPin:mode: message. The first argument of the message is the number of the pin, and the second is a numeric value representing the output mode value. We use the FirmataConstants class that encapsulates many of the different numeric values used by firmata. In the following example, we set the digital pin 13 in output mode, so we can write to it.
firmata digitalPin: 13 mode: FirmataConstants pinModeOutput.We can then write to a digital port with the #digitalWrite:value: message, giving the pin number as first argument, and the value to write (0 or 1) as second argument. Thus, to turn on the pin 13 we can do:
firmata digitalWrite: 13 value: 1.And to turn it off:
firmata digitalWrite: 13 value: 0.To read from a digital pin, you should first set it to input mode using the #digitalPin:mode: message. The first argument of the message is the number of the pin, and the second is a numeric value representing the input mode value. We use the FirmataConstants class that encapsulates many of the different numeric values used by firmata.
In the following example, we first setup a push down button with a pull-down resistor. We connect the button output to digital pin 2. When we push the button and Firmata should tell us that the value of pin 2 is 1. When we do not push it, its value should be 0.
First, we set the digital pin 2 in input mode, so we can read from it.
firmata digitalPin: 2 mode: FirmataConstants pinModeInput.Then, we can read the value of the pin using the #digitalRead: message.
firmata digitalRead: 2.If we ask the value and press the button at the same time, we get the value 1.
Analog pins are pins whose state range in the continuum between 0 and 1. These states are represented as floating point numbers.
As with digital pins, analog pins work both in read and write mode. Typical usages of reading analog pins is retrieving data from sensors, such as temperature, humidity, light and so on. Writing analog pins can be used to, for example, turn on leds with a given intensity instead of just "turning on" like we do with the digital pins.
firmata activateAnalogPin: 0.((firmata analogRead: 0) * 500 / 1024) asFloat.